The Dynisco PTJA Washable Pressure Sensor is designed for applications requiring a zero volume pressure port. The recessed diaphragm improves the frequency response. The PTJA has a full 3 mV / V output signal and offers reliable and accurate pressure measurement of gases, viscous liquids. First make sure that the +24 VDC is connected to the transducer's + excitation and VDC to common. Then disconnect the wire that runs form the transmitter's + signal to the control circuit. Now place the voltmeter + lead onto the transducer's + signal and the voltmeter - onto common. With no pressure applied, the transmitter should provide a. www.doorway.ru P/N: N/ e: N/ ECO: N/ Pressure ranges Pressure ranges in bar Max. Overload Burst pressure Limit frequency Rigid stem/flexible stem Electrical Data Temperature influence EMC requirements Materials Mounting torque Environmental Protection Weight DimensionsFile Size: KB.
The Dynisco Melt Pressure Transducer is used to make pressure measurements of molten polymers up to ßF (ßC). These models incorporate a Ohm, bonded foil strain gage Wheatstone Bridge. This proven technology provides an output of 0 - mV/V (nominal), proportional to melt pressure (within the specified error band). The full-scale output of the PT pressure transducer is 3 mV/V. The power supply should be well regulated with recommended excitation of 10 Vdc, 15 Vdc maximum to the transducer. Six conductor-shielded cable, such as Dynisco P/N , should be used for transducer connections. Internal Shunt Calibration. Dynisco-Viatran. Lot , Jalan SM 6/8 Seri Manjung, Perak, Malaysia +
isolation or where installation would be otherwise difficult or impractical. 3 Styles of Melt Pressure Transducers for Extrusion Processing. There should be NO pressure applied at this time. 4. Connect power to the sensor using the chart below. Standard configurations shown. See complete manual. Dynisco holds the original patent for the melt pressure sensor used is to follow the instructions for both the instrument and the sensor.
0コメント